Ubiquiti Networks LiteStation2 Guide de l'utilisateur Page 1

PowerStation2LiteStation2LiteStation5User’s Guide© Copyright 2007 Ubiquiti Networks Inc. All rights reserved.

9Use antenna alignment tool to adjust the device antenna to get better link with the wireless device. The antenna of wireless client has to be adjust

10 Extra Info: displays the current usage statistics in pop-up window: Show Stations… selection lists the stations which are connected to the device

11 Link Setup The Link Setup page allows you to manage general wireless connection parameters of the device. Basic Wireless Settings The general wi

12 Channel: select the operating channel while operating in Access Point mode. Multiple frequency channels are available to avoid interference betwee

13 Figure 10 – Site Survey Scan Select the Access Point from the list and click Select button for association. Click Scan button to refresh the lis

14 Authentication Type: choose the one of the following authentication modes for WEP security method: Open Authentication – station is authenticated

15 Network Settings PowerStation2/LiteStation2 and LiteStation5 can operate in bridge or router mode. The IP configuration as described below is req

16 Figure 15 – Router mode Network Settings There are two network segments (WLAN and LAN) configured separately when device is operating in Router m

17 LAN IP settings can be assigned automatically using the DHCP or PPPoE. If PPPoE mode is selected, the Username and Password credentials are requir

18 Distance: specify the distance value in miles using slider or enter the value manually. The signal strength and throughput falls off with range. C

1Contents INTRODUCTION...2 QUICK SETUP GUIDE...

19 Antenna polarity defines embedded hi-gain antenna polarity: Vertical – switches vertical antenna polarity. Horizontal – switches horizontal antenn

20 Services This page covers the configuration of system management services SNMP and Ping Watchdog. Ping Watchdog Ping Watchdog is dedicated for con

21 Figure 22 – SNMP Agent Configuration Enable SNMP Agent: control will enable SNMP Agent. SNMP Community: specify SNMP community string. It is requ

22 After the Upgrade… button is clicked the new Firmware Upload pop-up window will be displayed: Figure 24 – Firmware Upgrade. Step 2 Current Firmwa

23 Host Name Host Name is the system wide device identifier. It is reported by SNMP Agent to authorized management stations. Figure 27 - Host Name C

24 To upload new logo, enable logo customization and specify the location of logo file: Figure 29 – Custom Logo Upload Enable Custom Logo: control w

25 Reboot: click to hard-reboot the device in the current configuration. Any non-applied changes will be lost. Reset to Defaults: click to reset the

2Introduction This guide presents the description of the subscriber stations LiteStation2, LiteStation5 and the outdoor wireless station PowerStatio

3Quick Setup Guide This Quick Setup Guide will guide you through quick and easy configuration of the subscriber station (client bridge) including: 

4Bridge IP Address: specify the IP mode: DHCP – choose to assign the dynamic IP address, Gateway and DNS address by the local DHCP server. Static – c

5A (Dynamic Turbo) – connect to a 802.11a network which supports Dynamic Turbo feature. A (Static Turbo) – connect to a 802.11a network which support

6WPA Pre-shared Key: enter a passphrase for WPA™ or WPA2™ encryption. The pre-shared key is an alpha-numeric password between 8 and 63 characters lon

7Configuration Guide Each of the web management pages (listed below) contains parameters that affect a specific aspect of the device: Figure 1 – Co

8Main Settings This page displays a summary of status information. It shows important information for the device operating mode, network settings as