Ubiquiti Networks LiteStation2 Guide de l'utilisateur

LiteStation2 LiteStation5 User’s Guide

Figure 3 – Antenna alignment Tool TX Rate: displays the current data transmission rate. RX Rate: displays the current data reception rate. Channel:

ESSID: specify the ESSID of the wireless network device where the LiteStation2/LiteStation5 will be associated to. Use the Select… button next to ESS

support Static Turbo for data rates up to 108 Mbps. A Dynamic Turbo – allows connection to 802.11a networks that support Dynamic Turbo for data rates

Key Type: use the HEX or ASCII option to specify the character format for the WEP key. Key Index: specify the Index of WEP Key. WEP Key: enter the enc

IP Address: enter IP address for subscriber station LiteStation2/LiteStation5 Netmask: enter a subnet mask for subscriber station LiteStation2/LiteSta

ACK Timeout: specify the ACK timeout (integer, 20-520). This is the amount of time the subscriber station will wait to hear a response from the wirele

TX Antenna – choose the single antenna Main or Aux for transmitting. RX Antenna – choose the single antenna Main or Aux for receiving. System This pa

Figure 15 – Firmware Upgrade 3 After clicking the Upgrade button the upgrade process starts immediately: Figure 16 – Progress of the Firmware Upgrad

Logo Customization Use this section to enable and upload your custom logo on the LiteStation2/LiteStation5 user interface. The logo must conform to th

Contents Contents... 2 Introduction...

Introduction This guide presents the description of two models of the subscriber stations: LiteStation2 and LiteStation5. LiteStation2 is a subscribe

Quick Setup Guide If you do not change any of configuration parameters the default values will be used. This Quick Setup Guide will guide you thro

IP Address: enter IP address for subscriber station LiteStation2/LiteStation5. Netmask: enter a subnet mask for subscriber station LiteStation2/LiteSt

support Static Turbo for data rates up to 108 Mbps. A Dynamic Turbo – allows connection to 802.11a networks that support Dynamic Turbo for data rates

Step 6 Change administrator password The default administrator settings are:  Username – ubnt  Password – ubnt For the security reasons the

Configuration Guide Each of the management windows (listed below) contains parameters that affect a specific aspect of the subscriber station: Figur

Main Settings This page displays a summary of status information of your subscriber station LiteStation2/LiteStation5. It shows important information