Ubiquiti Networks UniFi AP Guide de l'utilisateur télécharger pdf (Page 6)

Hardware Installation

The UniFi AP‑PRO can be mounted to the wall or ceiling.

Perform the steps for the appropriate installation:

Wall Mount

1. Position the Mounting Bracket at the desired location on

the wall with the cable feed slot pointed towards the floor.

2. Use a pencil to mark the three holes on the wall. Use a

6mm (¼") drill bit to drill the holes.

Top

Optional 25 mm (1 in) Hole for

Ethernet Cable Feed through Wall

3. Follow the instruction for your Ethernet cable feed:

‑ Feeds Through the Wall Cut or drill a circle

approximately 25 mm (1 in) in diameter, just below

the bottom center of the Mounting Bracket (as shown

above). Then feed the CAT5/6 cable through the hole.

‑ Feeds Along the Mounting Surface Remove the

Cable Feed Plug on the side of the UniFi AP‑PRO.

*640-00042-03*

640-00042-03

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Pas de commentaire

Ubiquiti Networks UniFi AP Guide de l'utilisateur Page 6