Ubiquiti Networks UniFi AP Pro Guide de l'utilisateur télécharger pdf (Page 12)

Chapter 2: InstallationUniFi

™

AP-PRO and AP-AC User Guide

Ubiquiti Networks, Inc.

Ceiling Mount

1. Remove the ceiling tile.

2. Place the Ceiling Backing Plate in the center of the

ceiling tile. Mark the four mounting screw holes and 25

mm hole for the Ethernet cable feed.

25 mm Hole for Ethernet Cable Feed

3. Use a 3 mm drill bit to drill the screw holes, and cut or

drill the hole for the Ethernet cable feed.

4. Secure the Mounting Bracket to the ceiling tile using the

Ceiling Backing Plate, M3x50 Flathead Screws, and M3

Keps Nuts.

5. Feed the Ethernet cable through the 25 mm hole.

6. Set the ceiling tile back into place.

7. Connect the Ethernet cable to the Main port.

MAIN

SECONDARY

This device complies with Part 15 of FCC rules.

Operation is subject to the following 2 conditions:

1) this device may not cause harmful interferen ce

and, 2) this device mu st accept any in terferenc e

received, inc luding inte rferenc e that may cau se

undesire d opera tion.

FCC ID: SWX-UAPAC I C: 6 54 5A- UA PAC

0560

M/N: U AP-A C 4 8V 0.5A POE

AP AC

8. Align the slots on the UniFi AP with the tabs on the

Mounting Bracket.

9. Slide the UniFi AP down until it locks into place.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 62 63

Pas de commentaire

Ubiquiti Networks UniFi AP Pro Guide de l'utilisateur Page 12