Ubiquiti Networks AF-24 Guide de l'utilisateur télécharger pdf (Page 23)

2. For the Master and Slave, ensure the Azimuth (AZ) and

Elevation (EL) Adjustment Bolts are in the middle of their

adjustmentranges.

Elevation (EL)

Adjustment Bolt

Azimuth (AZ)

Adjustment Bolt

3. Master Aim the Master at the Slave. If necessary, adjust the

Master's position on the pole:

a. Loosen the Hex Nuts.

b. Adjust the Pole Mount Bracket and Pole Clamps.

c. Tighten the Hex Nuts.

Hex Nuts

4. Slave Aim the Slave at the Master to achieve the strongest

received signal level on the Slave's numeric LED Display, which

is located next to the CONFIG port. If necessary, adjust the

Slave's position on the pole.

Slave RF Power (-dBm)

Note: Values on the LED Display are displayed in

negative (-) dBm. For example, 61 represents -61dBm,

which is stronger than -72 dBm.

Alignment

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Pas de commentaire

Ubiquiti Networks AF-24 Guide de l'utilisateur Page 23