Ubiquiti-networks UniF AP AC Manuel d'utilisateur télécharger pdf (Page 6)

Hardware Installation

The UniFi AP can be mounted on the wall or ceiling. Perform

the steps for the appropriate installation:

Wall Mount

1. Position the Mounting Bracket at the desired location on

the wall with the cable feed slot pointed towards the floor.

2. Use a pencil to mark the four mounting holes. Use a 6 mm

drill bit to drill the mounting holes.

Top

Optional 25 mm Hole for

Ethernet Cable Feed through Wall

3. Follow the instruction for your type of Ethernet cable feed:

- Feeds Through the Wall Cut or drill a circle

approximately 25 mm in diameter, just below the

bottom center of the Mounting Bracket (as shown

above). Then feed the CAT5/6 cable through the hole.

- Feeds Along the Mounting Surface Remove the

Cable Feed Plug on the side of the UniFi AP.

*640-00076-04*

640-00076-04

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Pas de commentaire

Ubiquiti-networks UniF AP AC Manuel d'utilisateur Page 6