Ubiquiti Networks AF-24 Guide de l'utilisateur télécharger pdf (Page 14)

7. Configure the Wireless Security:

a. Select the AES Key Type, HEX or ASCII.

b. For the Key field:

- HEX Enter 16 bytes (eight, 16-bit HEX values: 0-9, A-F, or

a-f). You can omit zeroes and use colons, similar to the

IPv6 format.

Note: The airFiber Configuration Interface supports

IPv6 formats excluding dotted quad and "::"

(double-colon) notation.

- ASCII Enter a combination of alphanumeric characters (0-9,

A-Z, or a-z).

8. Click Change and then click Apply.

9. In-Band Management is enabled by default, so each airFiber

radio must have a unique IP Address. (If the airFiber radios use

the same IP Address, then you may lose access to the airFiber

radios via the DATA ports.) To change the networksettings:

a. Click the Network tab.

b. Change the IP Address, Netmask, and other settings to make

them compatible with your network.

c. Click Change and then click Apply.

Repeat the instructions in the airFiber Configuration section on

your other airFiber radio. After you have configured the airFiber

radios, disconnect them and move them to your installation site.

airFiber® AF-24 Quick Start Guide

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Pas de commentaire

Ubiquiti Networks AF-24 Guide de l'utilisateur Page 14